Quote:
Originally Posted by Ol Blue K20
Sounds like you may get through that punch list yet.
|
Two steps forward, one step back, Dale. But I plan to succeed.
Quote:
Originally Posted by Blue GMC
Man I am truly impressed!!! Read the whole build in the last 2 days and it has got to be frustrating to bee so close when the gremlins started. Looking forward to seeing the final solution to the problems had the same issues with heat and ac on my truck and 10 years later still fighting the trans.
|
Thanks! I've never had a build with so many things go kaput - particularly at the end when it should be just minor tweaking.
Case in point, after my test drive yesterday, I decided to change the adjustment on the shocks just slightly. When I reached under the driver side rear for the knob, I grabbed the tire and realized the backside was greasy/sticky. Upon further inspection, I could see the axle seal has been leaking. Not a huge amount, but more than enough to cause problems. The caliper, rotor, e-brake and the inside of the rim were coated with 90W rear end grease. A small amount had slung up into the wheel well, but it didn't appear to be dripping off of anything - yet.
So, the axle is out and a cursory look see didn't reveal any obvious defects. The axle assembly came preassembled with the chassis from Roadster Shop. I reckon I need to get a good light and my magnifier to see if I can find the cause of the leak and then come up with a plan to fix it.