Re: 1965 C10 Fleet Project - unfinished business
Lots of stuff going on but have managed to do some prep and paint on the big stuff. I am crossing all my fingers that a house purchase goes through - one big reason being its got a garage :-)
Got the front crossmember painted with a couple of coats of grey epoxy gloss after opening up the control arm holes to accept the bigger U bolts.
Fitted the rear cab mounts (back in their new short-bed position).
Prepped the rear axle with temporary diff cover and again got some epoxy primer and topcoat on nice and thick - this stuff goes off like concrete but takes about 7 days to fully cure.
And finally the wind-chimes all primed and coated with a few coats of grey topcoat (minus the bushings) that are ready and waiting.
Hopefully during next week after work I can bolt the rear end back together with blocks, springs and hardware - feels good to be start putting this jigsaw back together...
__________________
1965 c10 project - how does all this stuff go back together...
|