The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kwmech** · 12-17-2021, 01:56 PM

450 sounds a bit too high, but I haven't priced this stuff recently with the 'world crisis'. Ask them about the counter shaft spacer between 3rd and 4th. You will remove the outer snap ring, press off the largest gear and remove 2 snap rings, then install the spacer and put the gear back on with the outer ring. I see that mod hasn't been done by your second pic. Also see if they have the spring and detent kit for the top cover. If an output shaft is available I would replace it. The sleeve looks ok. Also see if Anaheim has the socket to remove the nut.

12-17-2021, 01:56 PM	#21
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,428	Re: Metal shavings in a manual trans 450 sounds a bit too high, but I haven't priced this stuff recently with the 'world crisis'. Ask them about the counter shaft spacer between 3rd and 4th. You will remove the outer snap ring, press off the largest gear and remove 2 snap rings, then install the spacer and put the gear back on with the outer ring. I see that mod hasn't been done by your second pic. Also see if they have the spring and detent kit for the top cover. If an output shaft is available I would replace it. The sleeve looks ok. Also see if Anaheim has the socket to remove the nut.