Quote:
Originally Posted by mongocanfly
What Scoti suggested is basically how I just did mine on the IH.. I clamped angle iron on frame rails and laid a 1x on top to set my pipe height 3/4" above the bottom of the frame rail..laid my long straight sections of pipe on that and clamped it down, then fanangled my bends to connect point A to B..
It's hard to visualize yours without seeing it..
Are you building this yourself, or letting a muffler shop do it?
|
I started out to but my welder took a dump so I was going to get a muffler shop to do it. I wanted some pics to show its possible to run it from the exhaust mani to the kick up at the chassis then to rear of the front tire.
I figure it's only 2" pipe so a 90 should work and still have room at the front shock and tire.