[QBRacing]

@springm
When I took it for the cert check, other than door alignment issues, he never said anything about them but they were on my pre build which was approved by LVVTA ... so pass.

In regards to updates , whilst slow i have progress. I now have a 50sq meter (540sq ft) shed in the back yard with a 3m stud and a fully working clearfloor 2 post hoist .... yay...

I have also installed the LS6 valley plate so I could run the PCV system as required by the LVVTA cert process. I got lucky on that front as I happened to have the late LS1 block without the plug that interferes with the PCV block under the valley plate so there was no alloy shaving to get it to fit. With a small bend to the output pipe it nicely cleared the steam vent system I have too

now to fix the chassis flex and the steering column then I can get a recheck and hopefully on the road.