[Ol Blue K20]

Originally Posted by Steeveedee

I went up to the hardware store to get wire and conduit, etc., to run 220 to my new table saw. I was looking at jacks and plugs and other such nonsense when I remembered that I had an extension cord that I used to use for a 6 HP planer-molder that I have since sold. Since the new saw is 3 HP and draws less amps, I'm going to save myself a couple hundred dollars. All I need is one jack on the end of that cord that my saw can plug into. SCORE!

Nice! Make sure you don't trip on the cord. OSHA hates trip hazards!