Carrying on with the blower heater unit….
We wonder where the time goes on this build, here is where.
Best part of a few hours.
First side exit in place, this took a lot of time, due to various angles of intersection.
Into position goes no 2 after a lot of trimming etc.
Side panel and vent all need to be in concert.
Bonded in place and fixed with tape, lets see what happened overnight.
While the glue was drying on the blower, I returned to the kick panel I previously managed to screw up royally.
The foam had dried on the board, so glue on the new vinyl and backing……
Result.
Right,mguess,it is 11.15 so I need to go outside and finish a “pivotal” job started last night.
More about that later.