[Boog]

In the second pic that wire spring is shown installed wrong. It holds the locking pin in place to move it back and forth. The rod sticking out to the left is the dimmer switch rod and has to be in just the right spot to work.
In the third pic I am pointing to the ignition switch actuator linkage and also has to be placed just right. As you disassemble it these small parts tend to move and or pop out of place.
In the fourth pic I am using the pivot pin remover to remove the inner “cage” for lack of a better word.
No further disassembly is needed.
In the fifth pic you see I just moved the shaft over enough to remove the bolts.
Reverse order for assembly. Hope it helps someone.