Quote:
Originally Posted by Jason Banks
Have you seen this thread, post #37
https://www.67-72chevytrucks.com/vbo...=790866&page=2
Where Todd mentions the wider frame rails of the earlier trucks?
Seems like you have this worked out. I would bet, if the factory engine stands are interchangeable between C10 and C20, the Holley probably would be too.
I was always under the impression that the C20 frame rails are taller, but that may not start until under the cab.
|
Jason- I read it before I ran into this and forgot. Could you please confirm:
-Your frame is a c20 and what year
-Measure the width of one frame rail at the middle engine mount hole (2 3/8" or 1 3/4"?)
-Which engine mount part number did you order
I think if you could confirm that I could probably confirm my guess. All is much appreciated Gents