Thread
:
My 1967 Build (Finally)
View Single Post
06-03-2022, 09:20 AM
#
69
KyleSeal
Senior Member
Join Date: Mar 2014
Location: Toano, VA
Posts: 880
Re: My 1967 Build (Finally)
Placed and welded in the drivers side floor pan last night, went it pretty well - the outer portion of the pan, where the rocker, kick panel, and a-pillar fit together is seemingly stamped about .5inch off to the rear. I will just install the inner rocker piece in that area and stitch weld it together. I used the block of wood with a bolt through the cab support to hold the pan tight to the support plate to minimize the amount of gap, and avoid pushing down with a hammer handle.
__________________
"Sometimes I do serve as a good bad example. Glad to be of service."
My Build Thread (1967 C10, lowered, EFI, daily truck):
http://67-72chevytrucks.com/vboard/s...d.php?t=830809
KyleSeal
View Public Profile
Find More Posts by KyleSeal