Update. When I last posted, I thought the cab almost finished. After the cut and buff it became obvious I had experienced solvent pop. This means I have to redo most of the cab.
Temperature was too cold in the garage for the reducer/hardener I was using. That being said I put the suspension and frame back together and put the cab back on. I was hoping to install the engine for the last time, but left it out until the cab is redone. Had to play adult Tetris with the garage to get the daily driver back in for winter. That was a month ago. Got ready for winter & went hunting.
Motivation… a friend came across 10 of these 1” rough cut curly maple. So all the wood will be redone! Why not, but you can’t beat the price.
Today… back at it again. Thought I would start small. Just the steps. Different clear and different base reducer. I’m going to cut and buff Tuesday. If it looks ok, I’m going back to the cab.