Quote:
Originally Posted by hatzie
Potting the board is a good idea.
Some marine resins are UV curing.
What happens when you expose the resin to black light?
|
I used some resin I had left over from reconstructing my dashboard. It uses hardener, but I set them out in the sun anyways until I knew it wasn't going to dry. I squirted more hardener on top, only the hardener dried a little. I need the bulb tabs so I pulled them all apart, clipped off the wires and threw them in gasoline. That stuff is nasty and it wasn't coming off. I burned the gas off them twice and they were still sticky, so I left them soaking for a while. I just burned them all again over a candle and the gas soaked in to the stuff but I still had to burn them for a while. Now they're clean. I'll do it all over again but this time I'm getting fresh epoxy.