[nvrsatisfied]

while finishing up the door edge the work bled over to the inner part of the b pillar. we started cleaning out the filler that was caked inside the pillar hiding their previous work on the latches they added in and covering the original catch location. we left their cover plate over the catch area and cut out a small section to locate the nuts on the back side. i then pondered on weather or not to just put a piece in to cover the holes and then add weld, reshape the area they used for their door catch. but i couldn't, i think it would've look like we were covering up something. so i went ahead and cut out the area and took a small patch piece and ran it through the bead roller. i had to mismatch some dies to try and get the roll, i think i got the roll good enough but not exact, but it'll work.