Made some progress this evening. Finally got all the parts out.
Had to dig through some greasy dirt to find the pin that keeps the countershaft in place. Also ended up punching a hole in the plug over the tail shaft snap ring, so I’ll have to weld that back together. But at least it’s all apart and I can clean all the parts this weekend. Tomorrow after work I’ll take some time to hang up some lights over the work bench. Had to rely on some flash lights this evening
__________________
Christian Carpenter
1963 C10 -
Frankentruck 283, Muncie 3 speed with overdrive
Overdrive wiring here
1963-ish truck bed trailer -
Half-Wit
1981 C10 -
Penny 305, th350 --> Soon to be 350, Saginaw 4 speed
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson