The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Stocker** · 07-05-2016, 07:42 PM

Got mine today, they look great and I hope to install them soon. Got a question about the hardware, though. I know there's extra stuff in the bag. I went to the mfgr's website for specific instructions and it shows the angle brackets and the large round washers in the '67-'72 kit, but doesn't show them being used. Not needed? Just extra stuff to hang onto forever, like all my other miscellaneous hardware & junk?

Edit: Just as I suspected.... I went back to the website, looked at the universal application this time.... sure enough, that's where the extra parts would be used, if original belts had not been factory installed.

07-05-2016, 07:42 PM	#152
Stocker 20' Daredevil (Ret) Join Date: May 2003 Location: Jefferson State Posts: 13,517	Re: 3 point shoulder belts Got mine today, they look great and I hope to install them soon. Got a question about the hardware, though. I know there's extra stuff in the bag. I went to the mfgr's website for specific instructions and it shows the angle brackets and the large round washers in the '67-'72 kit, but doesn't show them being used. Not needed? Just extra stuff to hang onto forever, like all my other miscellaneous hardware & junk? Edit: Just as I suspected.... I went back to the website, looked at the universal application this time.... sure enough, that's where the extra parts would be used, if original belts had not been factory installed. __________________ - Mike - 1972 K20 LWB 350/350/205 RIP El Jay Last edited by Stocker; 07-05-2016 at 07:53 PM.