I have some issues and I need some guidance.
I mocked up the truck.
IMG_0177 by
Robert Moorman, on Flickr
Then I took a shot of the rear wheels in the wheel well straight on.
IMG_0178 by
Robert Moorman, on Flickr
Then the front.
IMG_0179 by
Robert Moorman, on Flickr
I think the tires look pretty close to centered in the openings.
Then I checked the bed to cab fit.
IMG_0180 by
Robert Moorman, on Flickr
That's about 1.25" from the back of the cab to the front of the bed.
Is that a good clearance or should it be a little more?
Then I looked at the tailgate end.
IMG_0181 by
Robert Moorman, on Flickr
I have not read about cutting the rear frame on the S10 frame, but if I did everything else right, it needs to be trimmed.
Has anyone else cut the rear frame to fit the truck?
I read the how to fit the hood instructions, so I started on that.
IMG_0183 by
Robert Moorman, on Flickr
On the driver's side, it's pretty close, BUT on the rider's side,
IMG_0184 by
Robert Moorman, on Flickr
The rider's fender is back as far as it will go. I have about 1/4" gap between the hood and the cowl indent on both sides.
Any ideas?