[jjzepplin]

So after getting the broken bolt out and successfully removing the rest of them, I put the Speed Engineering headers on. I was able to get the front O2 sensors to reach the headers. The header Y pipe has a fitting for a Fuel ratio sensor which is nice and I will be getting one of those before I attempt to tune it. I connected the headers to the stock muffler with that last little muffler thingy removed and not sure what to do with the valve flapper dealy. I think they put that there for the AFM to not sound so bad through the exhaust. These headers fit nice and slipped right in from the bottom. The only thing I am not a big fan of is the Clamping system allows for small leaks. I will fiddle with them occasionally to see if I can correct this. They are much louder than I expected with the big 3" Y pipe. A very noticeable acceleration improvement.