The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 69 Chevy C20 HO52 full floating rear end drum brake removal/installation.

treveiger · 02-13-2015, 12:06 AM

The picture above is also the orientation, Axle Nut, Nut Lock and Washer. That will be the order that they will need to go back in. Once all that is done the Hub/Drum Assembly SHOULD slide off, if it does not the shoe might be pressed against the drum. If this is the case you will need to back off the adjusting screw inside the drum through the little slot at the bottom of the drum and back off the shoe in the drum to get out the Hub/Drum Assembly. Take caution in taking these off the axle as these are heavy. Once the Hub/Drum Assembly is off you will should see the picture below.

02-13-2015, 12:06 AM	#9
treveiger Senior Member Join Date: Jul 2010 Location: South Dakota Posts: 4,092	Re: 69 Chevy C20 HO52 full floating rear end drum brake removal/installation. The picture above is also the orientation, Axle Nut, Nut Lock and Washer. That will be the order that they will need to go back in. Once all that is done the Hub/Drum Assembly SHOULD slide off, if it does not the shoe might be pressed against the drum. If this is the case you will need to back off the adjusting screw inside the drum through the little slot at the bottom of the drum and back off the shoe in the drum to get out the Hub/Drum Assembly. Take caution in taking these off the axle as these are heavy. Once the Hub/Drum Assembly is off you will should see the picture below. Attached Images __________________ 1969 Chevy c20(Miss Hackjob)