Re: Project: Recycle
With the rear frame 'clip' welded (fixed) in place, we loosened up the front frame section that was held in place on 3" square tubing w/rachet straps @ the 4 cab mount corners.
I relocated the front frame section by removing the 3" square tubing & pulling the front rear back together again. I welded the splice to keep things square while I made the gusseting plate (fish plates).
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 01-17-2010 at 09:45 PM.
|