Re: Need little bag over axle advice
ok, drivetrain installed, im ordering up the TA brackets now, so my rear end is up on jackstands and so is the frame. im assuming the truck has to be flat on the floor to measure angle of the output shaft and the also the rearend housing?
im also wondering if i should go ahead and get a drive shaft made, and bolt it up as normal with the TA's and then start messing with angles? i currently have the stock 2 piece but would actually like to have it a 1 piece if possible.
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread
-_--_--_ _________
_--_-_ -/____|__|__\__
,.,,,.,.,,.,|_O _______ O_]
|