Re: Rear roll pan
When I was getting ready to go to Bonneville in 1998 I snagged a piece of used stainless pipe at work and cut it to length and took some flat stainless flat bar and made brackets and one of my vendors gave me two end plugs and my buddy welded in the end plugs and welded the brackets on to build a Gasser look stainless steel rear bumper.
That is where the bumper sits when you have it straight out from the ends of the frame rails.
__________________
Founding member of the too many projects, too little time and money club.
My ongoing truck projects:
48 Chev 3100 that will run a 292 Six.
71 GMC 2500 that is getting a Cad 500 transplant.
77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around.
|