The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Wgesnerjr** · 07-22-2020, 03:10 PM

I have this recollection - but not even 50% sure it's right, so use at your own risk.

But, I think CAN BUS wires are "Concentric Twisting" from the factory. Check you original harness to be sure but I think its done to minimize interference. Here is some light reading if you are having trouble sleeping. https://www.hpacademy.com/technical-...tric-twisting/

I did some CAN BUS wiring in a Grand Cherokee and I think they were twisted. Just because Chrysler did it doesn't make it right, but enough to consider.

If anyone knows more, please correct me.
Thanks.

07-22-2020, 03:10 PM	#6
Wgesnerjr Senior Member Join Date: Jun 2015 Location: Atlanta, GA. Posts: 737	Re: OBDii connector I have this recollection - but not even 50% sure it's right, so use at your own risk. But, I think CAN BUS wires are "Concentric Twisting" from the factory. Check you original harness to be sure but I think its done to minimize interference. Here is some light reading if you are having trouble sleeping. https://www.hpacademy.com/technical-...tric-twisting/ I did some CAN BUS wiring in a Grand Cherokee and I think they were twisted. Just because Chrysler did it doesn't make it right, but enough to consider. If anyone knows more, please correct me. Thanks. Attached Images __________________ Jay Gesner Atlanta, GA 1985 C10 Long Bed 4X2 LS 5.3, 4L60E Father/Daughter Project Last edited by Wgesnerjr; 07-22-2020 at 03:23 PM.