|
Re: HG's Dream Car Build - Shelby Cobra Kit
Even though I should be focused on the truck right now I've been dicking around with this front suspension stuff so long I had to see some progress. The right front suspension is in. The only real mistake I made was position of the cotter key hole in the upper ball joint. Made it difficult to get the pin in the hole. The directions are short on details about what bolts to use where. It's a mix of stuff from the kit and the donor but I figured it out. The other side should be easier.
Rear tubular control arms are bought and being shipped. Cheaper ebay set. I have a lot of work ahead with the rear axle yet.
|