The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 09-10-2021, 02:11 PM

So the Rezin Rockit is due for a full Polybush makeover.

https://forum.retro-rides.org/thread...in-rockit-year

So this is a kit available from floflex https://floflex.co.uk/product/cortin...set-inc-x-mem/

Cost is £152.00 plus shipping, probably £160.00 landed.

I have looked at the parts and tried to identify and align the various bushes with parts of the front and rear suspensions and crossmember

I have failed……

Has anyone done this swap before and used these products?

If so, based on this photo from the advertising online, can you identify where they,go ?

And related to this as far as I can see, the rear has a 16mm Anti Roll Bar which I do not believe has bushes in the kit.

So question no 2 for anyone who knows their Fords……….

Is there a bush kit, or way to replace these bushes?

The one is a double with the one side having a 12mm bolt keeping it in place, the outer diameters are 25 and 30mm for the two ends where they are bushed.

Any advice, thank you.

09-10-2021, 02:11 PM	#1303
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,481	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project So the Rezin Rockit is due for a full Polybush makeover. https://forum.retro-rides.org/thread...in-rockit-year So this is a kit available from floflex https://floflex.co.uk/product/cortin...set-inc-x-mem/ Cost is £152.00 plus shipping, probably £160.00 landed. I have looked at the parts and tried to identify and align the various bushes with parts of the front and rear suspensions and crossmember I have failed…… Has anyone done this swap before and used these products? If so, based on this photo from the advertising online, can you identify where they,go ? And related to this as far as I can see, the rear has a 16mm Anti Roll Bar which I do not believe has bushes in the kit. So question no 2 for anyone who knows their Fords………. Is there a bush kit, or way to replace these bushes? The one is a double with the one side having a 12mm bolt keeping it in place, the outer diameters are 25 and 30mm for the two ends where they are bushed. Any advice, thank you. __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.