The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kev2809** · 01-15-2022, 07:55 AM

well to be honest I would love to just slide the stock one. but the top rivets are a pain to get to. I measured the mounts before dropping it in the truck and had a feeling I would be a little short. now that pic I posted is with the trans sitting on my jack so the tail housing doesn't rest on the crossmember. I need to check the pinion where it's at but I'm sure I will need to let the jack down some. so not sure if a spacer will be needed

01-15-2022, 07:55 AM	#7
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,133	Re: Trans mount idea well to be honest I would love to just slide the stock one. but the top rivets are a pain to get to. I measured the mounts before dropping it in the truck and had a feeling I would be a little short. now that pic I posted is with the trans sitting on my jack so the tail housing doesn't rest on the crossmember. I need to check the pinion where it's at but I'm sure I will need to let the jack down some. so not sure if a spacer will be needed __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]