The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 01-31-2022, 05:44 PM

Big Milestone ???

Well, depends on what you look at.

@nickwheeler and I were talking and he said the screen support and anchoring the steering wheel would be a major milestone.

At this point one could start draping the loom and planning where stuff goes.

Relocating the air box and MAF meant I need to get some 65mm drain pipe to connect the air box and MAF Sensor.

Plus I need to order 100mm of 63mm inner diameter rubber hose to connect the extension pipe, MAF sensor and Airbox.

I also ordered a hole saw in order to cut some holes for the wiring looms to move about.

01-31-2022, 05:44 PM	#1559
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,486	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project Big Milestone ??? Well, depends on what you look at. @nickwheeler and I were talking and he said the screen support and anchoring the steering wheel would be a major milestone. At this point one could start draping the loom and planning where stuff goes. Relocating the air box and MAF meant I need to get some 65mm drain pipe to connect the air box and MAF Sensor. Plus I need to order 100mm of 63mm inner diameter rubber hose to connect the extension pipe, MAF sensor and Airbox. I also ordered a hole saw in order to cut some holes for the wiring looms to move about. __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.