[6DoF]

seat is officially placed, and temporarily secured. the rear mounts are bolted to the factory seat location then tacked to the seat frame. the delrin spacer blocks are just sitting there but will be screwed to the seat frame and not the floor just for support. thought, i might also delete em after the mount is fully welded since the seat leans on the back of the cab anyways. the forward mounts will be riv-nuts in the floor vs the current self tappers now that i know the placement is good. fold n tumble seat still works great too. with the console down you really notice the driver seat being offset probably 2-3" from center of the cluster.

fit the steering and kind of wish i had gotten the 28" vs the 30". i'd rather have the brushed natural finish, but the 3 different finishes kind of sucks, so i might try and get a black 28". in the picture you can see it exits the firewall really close to the frame, and i could use it a little further away from me inside at that placement.

also got the pedals bracket all modified and welded back together, easier than shipping them back to try something different. cut up my 2nd set for the clutch pedal, and spliced the bolts to make the length i needed to get thru the whole thing. it feels pretty good, but now i need to figure out the height to place the clutch master. i was shocked and excited tough that the pedal shaft that came with the hydroboost for whatever application was perfect as-is!