|
Re: Positive Camber with CPP drop spindles
Quote:
Originally Posted by Duncan K
I had a look at the assembly manual. I am pretty sure the controls arms are on the right sides. Looks like the angled side and the bump stop are to the rear. This is a photo of the passenger side
I stuck an angle gauge on the hub. It is showing 2 degrees. I am surprised it isn't more, it looks ridiculous looking at the wheel
I am going to pull all the shims and see where that gets me. |
I was going to say remove any/all shims. Keep them tagged for the location they were pulled w/a pic for reference.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|