The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**gemiii** · 12-08-2009, 07:27 PM

Heres a picture of the pass 1/4 on. I got 2 complete a pillars from Tom Korinek. Thanks again. They went from the cab support to the roof gutter including the inner kick panel. I dont think I would do this again. Lots of cutting and grinding. The only easy part was the 3 bolts to the side of the dash. I used them for alignment. Will the doors ever fit again? Am I wasting my time? What have I started? I cant wait to work on the chassis this sucks! I am still laid off so I am working 10 hrs a day on this POS! When the a pillar is cut out I am thinking I have got a pile of junk now. They went back in not too bad. Everything gets sprayed with rust inhabiter before it goes back together.

12-08-2009, 07:27 PM	#20
gemiii Registered User Join Date: Jan 2006 Location: Florida Posts: 121	Re: Project "Mid Life Crisis Low Rider Burb" Heres a picture of the pass 1/4 on. I got 2 complete a pillars from Tom Korinek. Thanks again. They went from the cab support to the roof gutter including the inner kick panel. I dont think I would do this again. Lots of cutting and grinding. The only easy part was the 3 bolts to the side of the dash. I used them for alignment. Will the doors ever fit again? Am I wasting my time? What have I started? I cant wait to work on the chassis this sucks! I am still laid off so I am working 10 hrs a day on this POS! When the a pillar is cut out I am thinking I have got a pile of junk now. They went back in not too bad. Everything gets sprayed with rust inhabiter before it goes back together. Attached Images __________________ 69 Camaro Convt 427 AT PW PT(since 83) 72 3/4 ton Suburban (Project Mid Life Crisis Low Rider Burb) 1930 Model A Tudor next project (ratrod)