[PGSigns]

I bought one of the woodward fab bead rollers. Found it online for $140 shipped. The dies don't come polished and the edges are a little sharp. So off to the lathe and cleaned up the machine work a bit and polished them up. Made a stand for it that I'll weld up once the power is on and an adjustable stop. I picked up the material for an air drier setup for the compressor. I made a stand up for using around the shop and used it to make the manifold up. Mounted it to a steel beam to act as a heat sink to improve the cooling in hopes of pulling more water out the air. I tied the drip legs together and set it up so I can drain any water into a bucket.
Jimmy