Finally got off my but today and did something. This is one of the custom mods that I have been planning for some time now and finally got the light in last week, my other way i was going to do the light was too much work but would have very cool the biggest problem was finding a light thin enough to fit so i had to find another light and this one seems to work pretty well.
1. measuring it out to make sure I have as close to center as possible.
2. Making a mess I should have used my 3" grinder but I have small air compressor and it does not keep up well with a air hog.
3. Clamped it up to get the bend i needed since this a concave curve it needed a little finesseing to get it to go up.
4. A little preflight testing to see what it was going to look like and make sure that it was going in the right direction.
5. Finally got it fitted and started tacking it in place and I ran out of wire, so this if as far as I got
