Re: Powersteering conversion issue
Quote:
Originally Posted by Charley7
So i have a 1971 c10 2wd. I’m trying to convert it from manual steering to power steering. I’ve read the swap info section a few times and searched this forum. I have steering gear 7802644 and found I needed a 6131 pitman arm. The issue is that the inner tie rod hits the crossmember before I can get the pitman arm on. It does have wilwood drop spindles on it.
Thanks for any further info.
Charley.
|
This is common when the center-link/drag-link is flipped when reassembling. The inner TRE's should not make contact w/the center x-member throughout lock-to-lock turning travel.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|