Quote:
Originally Posted by Flying Hamster
It LOOKS like that rusted thru from the back...
Was the other side of the metal repaired/treated/cleaned/painted?
|
No, I did not clean up the back side as stated in the original post.
Getting behind this “lip” is a bit of a challenge, that’s why the repair you can see in the interior photos is so ugly. I don’t know how to cut this 3/4” lip without cutting all the panels around it. It is almost impossible to get a cutoff wheel or Dremel back here.
I am going to try to cut on an angle and bend the lip back, sandblast and prime behind it, and seal it. Open to recommendations for the best way to work in the corner.