The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Ford Model A Tudor Modern Twist on a Classic

**gigamanx** · 04-22-2021, 05:46 PM

Couple of product shout outs from a novice..

USC 24030 Short strand went on smooth and was easy to sand. Follow directions, easy to do and manipulate before it sets.

Eastwood PRE wax and grease remover seems to be able to spray on pretty much any surface and leave a nice super clean finish to stick things like primer, body fill, base, and clear to.

Eastwood self-etching weld thru primer. The only spray can I've found so far that doesn't completely gum up after one or two uses leaving the remainder of a $15 can useless. Tried SEM and 3M

04-22-2021, 05:46 PM	#78
gigamanx Senior Member Join Date: Sep 2016 Location: Hershey, PA Posts: 1,004	Re: Ford Model A Tudor Modern Twist on a Classic Couple of product shout outs from a novice.. USC 24030 Short strand went on smooth and was easy to sand. Follow directions, easy to do and manipulate before it sets. Eastwood PRE wax and grease remover seems to be able to spray on pretty much any surface and leave a nice super clean finish to stick things like primer, body fill, base, and clear to. Eastwood self-etching weld thru primer. The only spray can I've found so far that doesn't completely gum up after one or two uses leaving the remainder of a $15 can useless. Tried SEM and 3M __________________ Current Build Thread 1930 Ford Model A Modern Twist: Ford Model A Rat Rod With a Modern Twist Build Thread Phase 1 "The Swap": 1949 3100 with S10 swap. Beginner build with ambition! Build Thread Phase 2 "The Drop": Beginner Build with Ambition gets Air Ride Last edited by gigamanx; 05-24-2021 at 02:52 PM.