View Single Post
Old 04-08-2021, 12:09 PM   #91
Keith Seymore
Registered User
Keith Seymore's Avatar
Join Date: May 2009
Location: Motor City
Posts: 8,332
Re: Hatzies 2005 2500HD

Just checking in to say that I'm still following along, and keep up the good work. I don't usually attempt a repair on my truck without checking here first.

Edit: just skimmed back through the thread to see what I had previously shared, and was reminded I wanted to do the steering wheel swap and add the DeeZee tailgate damper. I also am reminded that I prefer the '05 and up hood and grille as opposed to the '03/'04. Very slight changes but big improvement in the front end, in my way of thinking.

Originally Posted by hatzie View Post
A ring around the outside. Not enough to make one bit of difference.
Yep. That's "design intent", based on the size of the friction material and where it sits on the rotor. Every single truck of this configuration will have that.

Chevrolet Flint Assembly
GM Full Size Truck Engineering
1986 - 2019
Intro from an Old Assembly Guy:
My Pontiac story:
Chevelle intro:

Last edited by Keith Seymore; 04-08-2021 at 12:15 PM.
Keith Seymore is offline   Reply With Quote