Quote:
Originally Posted by 60-66
I cant tell exactly what you have but from the factory on a 1966 Chevy it used 2 stamped steel brackets, a cradle and an adjuster. My setup is a cast iron cradle and some steel brackets, l I think this setup actually started in 1969 ? I needed it to clear the large 400 balancer. Your crank pulleys are all different as you've already shown, they are offset more out than mine.
GMCs had either a V6 ( mine did originally ) or a straight six. V6 GMCs were reddish orange so I painted my 400 SB similar in just Chevy Orange. Your 327 in a 1966 Chevy truck was green ( referred to as Alpine Green ) and 283s grey.
|
unless they were Canadian built GMC, then they used the same engine setup as the Chevrolet trucks
ron