The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 02-28-2020, 05:36 PM

[url=https://flic.kr/p/2iyEDaq]20200228_102124

I've got brakes....

Not overly impressed with my chinese knockoff of a mighty vac. Zero setting was off by 4 inches of vacuum, fitting were a bit large to seal on the bleeder. I worked around them

Pumped it up to 25 inches, opened up the bleeder, and sucked fluid into the container. CAREFUL, the back chamber on the M/C is very small. On first pull, you can empty it quickly, after that you can fill up the cannister 1/2 way, before the chamber needs fluid

I bleed it down till I have about 10 inches then shut off bleeder

Great method for a one man bleeder

02-28-2020, 05:36 PM	#3217
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,428	Re: PO has me PO'd [url=https://flic.kr/p/2iyEDaq]20200228_102124 I've got brakes.... Not overly impressed with my chinese knockoff of a mighty vac. Zero setting was off by 4 inches of vacuum, fitting were a bit large to seal on the bleeder. I worked around them Pumped it up to 25 inches, opened up the bleeder, and sucked fluid into the container. CAREFUL, the back chamber on the M/C is very small. On first pull, you can empty it quickly, after that you can fill up the cannister 1/2 way, before the chamber needs fluid I bleed it down till I have about 10 inches then shut off bleeder Great method for a one man bleeder __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim