The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '50 Chevy S-10 Swap Build

Chevytruck10 · 08-06-2014, 08:37 PM

Then I went and did the passenger side cab corner.
Name: IMG_2482.jpg
Views: 945
Size: 47.4 KB

All was going good until I gouged the cut a little too high in one spot. Had to make a little filler piece to fix that.
Name: IMG_2485.jpg
Views: 973
Size: 57.9 KB

Name: IMG_2485.jpg
Views: 973
Size: 57.9 KB

Also, the rear door pillar was a little rusty so I cut out that area and made a piece to fill that in. It wasn't rusted on the bottomside like the driver's side was so I chose to just fill it in.
Name: IMG_2476.jpg
Views: 921
Size: 44.0 KB

Name: IMG_2476.jpg
Views: 921
Size: 44.0 KB

Name: IMG_2477.jpg
Views: 942
Size: 56.1 KB

Name: IMG_2479.jpg
Views: 928
Size: 56.1 KB

08-06-2014, 08:37 PM	#11
Chevytruck10 Registered User Join Date: Dec 2013 Location: Fort Worth, Texas Posts: 27	Re: '50 Chevy S-10 Swap Build Then I went and did the passenger side cab corner. All was going good until I gouged the cut a little too high in one spot. Had to make a little filler piece to fix that. Also, the rear door pillar was a little rusty so I cut out that area and made a piece to fill that in. It wasn't rusted on the bottomside like the driver's side was so I chose to just fill it in.