The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1968 GMC

**Jason Banks** · 10-31-2019, 10:15 AM

Did you use some kind of grommet where the wires come through the hump?

I want to do the same thing. I'm behind you and TA. I have Most of the metalwork done to my cab. Still need to weld on the rockers. I had to do outer floors, cab corners, cab supports, etc...It was 8 patch panels per side. With a sprinkling of other patches on the floor. My floor also had most of the welds broken at the front like yours. I say now...it would have been easier to do a whole floor, but much more money.

10-31-2019, 10:15 AM	#124
Jason Banks Senior Member Join Date: Dec 1999 Location: TX Posts: 1,519	Re: 1968 GMC - Ol' Blue Did you use some kind of grommet where the wires come through the hump? I want to do the same thing. I'm behind you and TA. I have Most of the metalwork done to my cab. Still need to weld on the rockers. I had to do outer floors, cab corners, cab supports, etc...It was 8 patch panels per side. With a sprinkling of other patches on the floor. My floor also had most of the welds broken at the front like yours. I say now...it would have been easier to do a whole floor, but much more money.