|
Re: Over 25 Years Later, Finally My 71 C-10 Truck Build
I got the fuel regulator and pressure guage ready to mount. The oil pan was off to attempt another fix of the timing chain cover to oil pan leak. That's already back in place. I switched where the temp probe goes into the intake so it is not squished under the radiator hose. I replaced the tranny dip stick O-ring and I have a new rear seal for the drive shaft yoke on order. I have new tranny and motor mounts for it too. I'm thinking about replacing the harmonic balancer because that little one is hard to judge the timing on so far from the tab. And I think I'm going to get new alternator brackets for it also.
I think it turned out pretty nice so far.
|