The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

D-n-Tyke · 06-18-2022, 06:13 PM

Thanks for the picture. I just placed my order yesterday. Starting out ar 3.5" up front (2.5 modual drop spindles and 1" lowering spring) and 4" drop springs in the back. We'll install all that and see how it looks and go from there. If it isn't low enough I also ordered up a 1" block so if I want to go lower I can cut 1/2 a coil up front and put that block in. Going to be a bit before I can get it all installed but will post up some pictures.

As for notching, I did order up a HD notch kit and will install that at the same time.

06-18-2022, 06:13 PM	#5
D-n-Tyke Registered User Join Date: Aug 2016 Location: El Cajon, CA Posts: 249	Re: Pictures of Lowered Burbs (3/5 vs 4/6) Thanks for the picture. I just placed my order yesterday. Starting out ar 3.5" up front (2.5 modual drop spindles and 1" lowering spring) and 4" drop springs in the back. We'll install all that and see how it looks and go from there. If it isn't low enough I also ordered up a 1" block so if I want to go lower I can cut 1/2 a coil up front and put that block in. Going to be a bit before I can get it all installed but will post up some pictures. As for notching, I did order up a HD notch kit and will install that at the same time.