[superflysteiny]

Sure I can answer that. The front fenders were drilled. So I found the old manuals on this forum that showed were and how the trim should be place. I also shows how far the holes should be placed apart. I took the measurements from the manual and the existing holes in the fenders and that was my starting point. I would tell you before you drill for the trim make sure all fender door gaps are correct and make sure bed is level and that all body mounts are good. If the mounts are old and cracked replace them first. My drivers side of the cab was lower by a quarter of an inch. So it is very important to check this before the bed is drilled. The kit was factory so it was retained with clip/nut and bolt trim tabs with plastic double sided tap. I was a long day putting the trim on because I had to almost pull the front clip off to get to the back side of the clips so I can put the nuts on. Hope this helps.
Posted via Mobile Device