The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Pontiac1976 · 05-01-2021, 08:53 PM

Well as mongocanfly has said. Because you should take a look at it. Because the square if I recall right it moves in side about a 1/4" all around for Adjustment’s of the striker to line up the door. And the big washer covers the hole ( so the hole smaller then the washer but bigger then the bolt) I would put your hand behind feel how it finished there.

Ho just the square is open just remembered

05-01-2021, 08:53 PM	#4
Pontiac1976 Registered User Join Date: Oct 2015 Location: Ottawa, Ontario, Canada Posts: 750	Re: door striker pic request Well as mongocanfly has said. Because you should take a look at it. Because the square if I recall right it moves in side about a 1/4" all around for Adjustment’s of the striker to line up the door. And the big washer covers the hole ( so the hole smaller then the washer but bigger then the bolt) I would put your hand behind feel how it finished there. Ho just the square is open just remembered __________________ 1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change. Last edited by Pontiac1976; 05-01-2021 at 08:59 PM.