[MrBlue]

We had the same issue when we installed our electric locks. It is an adjustment issue. The actuators will travel farther than the latch allows. I would suggest that you disconnect the power to the actuator. You will also need to disconnect it from the latch. Manually move the actuator up and mark the linkage. Now move the full down position and mark this. Next move the linkage to the middle of the travel. Do the same with the door lock rod. Once you have both in the middle, reconnect. Repeat for the other door. If the actuators are set up properly, you get the issue you are talking about. Good Luck,
MrBlue