Re: Holley 600 Rebuild / Overhaul
#2 NEXT WE CONTINUE GOING IN
this is the primary metering block, it has your power valve and two fuel jets attached.
be carefull not to break off the alignment tabs, these love to be stuck to the front of the carb body.
HERE you can see the fuel tranfer tube with the sealing rubbers on each end.
i also included a picture of the gasket remover .. good luck finding this stuff.
you can see how the gaskets love to stick every where.
USE YOUR GASKET REMOVER
Last edited by rage'nrat638; 07-25-2007 at 10:09 PM.
|