|
Re: Who has best replacment ring & pinions?
Quote:
Originally Posted by Richard
Used Yukon gears in my first gear change ever in my 94 C1500 daily driver and all is well after driving for almost 1000 miles. Decent prices and excellent customer service.
|
My very first, too. I bought a 3.42 gearset, bearings, etc. from Randy's Ring and Pinion (now Randy's Worldwide). Installed them in place of a 2.73 in a GM 10-bolt rear end. Had to call tech support a couple times, and they were very helpful.
Since then I have rebuilt two GM rear ends using the original gears and new bearings. Have to say even gearsets with over 150K miles still looked great and were very quiet. When properly set up, I suspect they would outlast most vehicles!
__________________
Mike
1969 C10 LWB -- owned for 34 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes.
1982 C10 SWB -- sold
1981 C10 Silverado LWB -- sold, but wish I still had it!
1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming.
Retired as a factory automation products salesman.
Worked part-time over the years for an engine builder and a classic car repair shop.
Member here for 23 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then!
Last edited by MikeB; 10-27-2021 at 10:10 AM.
|