|
Re: Wheel and tire selection
Quote:
Originally Posted by geezer#99
Unfortunately they don’t have one for a 6 bolt hub.
|
Piece of plywood, drill + bits, hole saw, & 2pcs of ~3/6 x 6" all thread will do the same thing if you like the reassurance of using something like that.
I have a couple of angle steel pieces from the hardware store (just like the article linked by Geezer#99). One is for 5x4.75 car pattern; the other is 5x5 truck. Same principle as the plywood set-up I suggested though. I use them or a wheel that fits & do the math from that. It's easy enough to do the measurements from there.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 05-19-2022 at 06:48 PM.
|