Quote:
Originally Posted by Hart_Rod
Have you connected a scanner to your OBD2 port to verify that i works OK? Also, you need to make sure the BIM is set to read the "J" protocol. It should work regardless if the engine is running or not as long as you turn the key on.
|
My reader caught the pcm through the OBDII and read it without issue.
I may have something not completely plugged in. I'll have to poke around some under the dash and see if I can reach stuff without diassembly.
I'll pull out the BIM manual and see what else I can learn about it and make sure its set up properly.
Thanks