[Roostre]

Clamps are off, and I have to say that I think the structural adhesive is the way to go here. Roof skin is nice and tight and I didn't have to drill any holes to spot weld it or worry about too much heat or burn through. I will replace the seam sealer, but that would have been done if I had welded it as well. I also didn't have to figure out how to spot weld the rear seam, or clean it up to weld it solid and again worry about too much heat or burn through. I'll have to put a little filler in there to even it out, but no big deal.

Long story short, I'm a fan of the adhesive for this part.