Quote:
Originally Posted by BMERDOC
If 1/4" is worth 1° on the bottom why not machine the uppers 1/8th" to have the extra .5" movement to equalize caster on both sides?
|
Not sure I'm following this. 1/8" (where?) equals .5"(where?).
Uppers back is a good idea, too. Before I found these threads I was only thinking of lowers forward cuz I also wanted to move the wheel forward in the well, mainly for cosmetics. Obviously, uppers back would negate a little of this, but I'd take 6 degrees over a perfectly centered wheel!